Service manual
17 of 46MAC Encore Performance - Revision A, 12-20-2017
Figure 30: Removing the pan bracket
Figure 29: Removing the four Torx20 screws
8. Remove the pan bracket (4).
NOTE! Notice the snap ring that holds the wire
guide yoke.
9. Loosen the locknut (5).
10. Push the locknut outwards to loosen the pan belt
(6).
11. Tighten the locknut to hold it in that position.
12. Replace the pan belt.
4
6
5
7. Remove the four Torx20 screws (3).
Figure 31: Replacing the pan belt
3
3
To Next Page
Loading...
