98
Chapter 6, Setting Up Realtime Effects with Adobe Premiere
Applying a pre-created basic DVE
When you apply a Matrox basic DVE, the Basic DVEs page appears:
°To set up a basic DVE:
1 Choose the type of effect you are looking for in the Directory. For example,
click the
PiP Effects folder under 3D DVE Effects to display a list of
available 3D picture-in-picture effects.
¦NoteThe available pre-created effects are the same as for an Advanced
DVE
(see “Applying a pre-created advanced DVE” on page 94). The basic
DVEs differ in that there are fewer settings that you can change, which allows
you to apply two basic DVEs on a clip in real time.
2 Click the particular effect you want from the Effect List.
3 To see a preview of your effect at any time, click the Preview button.
4 To create a soft edge on the border of your effect, select Allow changes,
then drag the
Softness slider. The higher the value, the less sharp the edge
of your clip becomes.
5 If you want to apply custom settings to your effect, see “Creating a custom
basic DVE” on page 99.
To Next Page
Loading...
