Page 115 of 188
User Manual MAS-100 Regulus en.docx, Version: 4.0
Note
Let the automated procedures run until they either finished successfully or are
automatically aborted by an error.
Note
The background information about the adjustment and calibration process of
the air samplers can be found in Annex A – Procedural background infor-
mation.
Note
The preset sampling volumes are intended to be nominal. Hence, the actual
sampled volume differs within the tolerance of the allowed deviation.
In certain application cases, it may be required to handle the preset volume
not as a nominal value, but as a minimum value instead. Such a requirement
can be easily implemented as described in Annex C – Nominal vs. minimal
sampling volume.
Note
Manual procedures for adjustment and calibration are the only option if an an-
emometer other than the MAS-100 Regulus or DA-100 NT is used.
To Next Page
Loading...