Page 50 of 188
User Manual MAS-100 Regulus en.docx, Version: 4.0
6.1. USER INTERFACE
The instrument features a built-in multilingual dialogue software. To navigate through the
graphic interface, follow the indications on the screen.
There are four buttons available. Buttons ❶ and ❷ are located underneath the screen and
are used for accepting or rejecting a suggested action. Buttons ❸ and ❹ on the right side
of the screen serve as arrow buttons (/) and are used to navigate up and down a menu
or to set values.
The red Stop-LED indicates that a sampling was stopped, e.g. after an alarm occurred.
The blue Run-LED indicates with continuous light that the instrument is ready for starting a
sampling. It flashes during a sampling or indicates waiting times (e.g. defined delays or
pauses between cycles in SQS mode).
When the instrument is switched off, the blue Run-LED indicates with flashing that the bat-
tery is being charged or, when permanently on, that the charging is completed.
❶ Lower left button
(Power switch)
❷
❸ Arrow down button ▼
❹ Arrow up button ▲
Illuminated graphic LCD display
Red Stop-LED
Blue Run-LED
To Next Page
Loading...