MBV MAS-100 Regulus - Impeller Running LED

Page 21 of 188
User Manual MAS-100 Regulus en.docx, Version: 4.0
Info screen 1
Shows information on the calibration status of the anemome-
ter:
– Last calibration: Date of the last calibration procedure.
– Maximum validity: Latest date on which the calibration is
still valid.
Info screen 2
Shows information on the usage history of the anemometer:
– Number of calibrations:
Shows how many calibrations have been performed so far
with the currently installed impeller.
– Usage counter:
Shows how long (in minutes) the anemometer has been in
use so far with the currently installed impeller.
Info screen 3
Shows information on the serial number and firmware version
of the anemometer.
Warning screen
Shows warnings to alert the user that something is critical or
needs to be done. Warning text appears between two black
horizontal bars.
For details about the different warnings refer to section 3.3.
2.7.2. IMPELLER RUNNING LED
The LED above the display indicates the following states:
The impeller running LED lights up when the impeller detects
a constant velocity.
The impeller running LED is flashing during the self-check
test.
Note: Do not remove the anemometer from the air sampler
as long as the impeller running LED is flashing.