MBV MAS-100 Regulus - Buttons

Page 22 of 188
User Manual MAS-100 Regulus en.docx, Version: 4.0
2.7.3. BUTTONS
The three buttons below the display have the following functions:
ON/OFF button
Switches the anemometer
on/off.
Reset:
Pressing and holding the button for 5 seconds causes a
hardware reset.
NOTE:
Performing a hardware reset does not result in a data
loss.
Units button
Switches between the measuring screens showing the values
in
the units SLPM and L/min.
Info button
S
witches between the different information screens (calibra-
tion status
, usage counter and serial number/firmware version
of the anemometer
).
NOTE: To acknowledge and quit a warning press any of the three buttons.