Page 133 of 188
User Manual MAS-100 Regulus en.docx, Version: 4.0
Note
If a problem or failure occurs during an adjustment or calibration, please refer
to chapter 11.8 or the troubleshooting.
Note
The background information about the adjustment and calibration process of
the air samplers can be found in Annex A – Procedural background infor-
mation.
Note
The preset sampling volumes are intended to be nominal. Hence, the actual
sampled volume differs within the tolerance of the allowed deviation.
In certain application cases, it may be required to handle the preset volume
not as a nominal value, but as a minimum value instead. Such a requirement
can be easily implemented as described in Annex C – Nominal vs. minimal
sampling volume.
To Next Page
Loading...