McHale Fusion 3 Baler & Wrapper
61
Screen Selection
There are two screen options for the Manual mode and two screen options for the
Automatic mode. The reason for this is to show extra information displays and different
functions for the softkeys.
7.2.3 Crop Types
There are three different crop types to choose from in the menu:
1. Straw
2. Hay
3. Silage
When Hay or Stray is selected, the wrapper will be disabled.
When Silage is selected, the wrapping will be switched on.
7.2.4 Film Layers
The selected number of rotations is displayed on the right side of the screen. On the
left side of the screen, the number of completed wraps over the target number of wraps
is displayed in the status box, when the wrapper is rotating.
7.2.5 Net Indicator
The net indicator (See No.16 of “Electronic Control System” on page 58) rotates when
net is being applied. This stops rotating when the net knife trips to cut the net.
7.2.6 Bale Counters
The bale sub total is displayed on the right side of the screen, if you cannot see it on
the screen, toggle to the other screen display by pressing the softkey D button. The
control box contains ten different bale counters (A-J) which can be reset and a grand
total counter which can not be reset. (See “Bale Count” on page 69)
7.2.7 Voltage Monitor
The control box monitors its operating voltage and displays it on the lower right side of
the screen. If the voltage falls below 10 volts the “LOW BATT” symbol is flashed on
the display.
7.2.8 Dispenser Speed RPM
The wrapper ring rotation speed, in revolutions per minute, is displayed over the
wrapper of the Fusion 3 image on the screen (Shown at No. 18).
To Next Page
Loading...
