Medifa 6000 - Leg Plate Adjustment Encoder System (Model 601920)

25
ww
qq
qq
ee
Service manual for medifa 6000 mobile operating tables, version 2.0
After you have removed the bolt [2], you can access the
screw [3]. Now remove the screw [3].
5.6.6 Displacement encoder system of the leg plate adjustment (Item No.: 601920)
Components column / top frame
To dismantle the leg plate cylinder displacement
measuring system, the cladding, pelvic padding plate and
support should be removed beforehand. Please refer to
the relevant chapters of this manual for instructions!
Move the longitudinal slide to the bottom side position
and the leg plates to the highest position.
Then remove the two screws [1] for fixing the
displacement encoder system. These are located on the
side of the pelvic rail.
Screw an M8 screw into the thread of the bolt [2] on the
inside of the pelvic rail.
Use pliers to remove the bolt [2] from the pelvic rail by
pulling on the screw.
Figure 34
Figure 35
Figure 36