Safety
10 D53182 02/2024
2.6 Changes and Alterations
Unauthorised changes or alterations must not be made to the appliance. Parts that are not
approved by the manufacturer must not be mounted or built in.
Unauthorised changes or alterations result in the CE declaration of conformity losing its
validity, and the appliance must no longer be operated.
The manufacturer is not liable for any damage, danger or injuries that emanating from
unauthorised changes or alterations, or from non-compliance with the provisions in this
manual.
2.7 Behaviour in case of Malfunctions and Irregularities
i
The unit must only be used in a flawless condition. If you, as the operator, notice
irregularities, malfunctions or damage, immediately turn off the unit and inform your line
manager.
i
You can find information on troubleshooting in the chapter }7Malfunctions, Warning and
Error Messages.
See also
2 Malfunctions, Warning and Error Messages [}39]
2.8 Switching off the Unit in an Emergency
WARNING
Hot surfaces
Depending on the operating situation, the unit and the load may be hot. Contact with hot
surfaces may have serious health consequences due to burns!
– Allow the unit to cool down.
– Wear heat-resistant protective gloves when carrying out work.
– Check the temperature of surfaces before touching them.
1. Press the main switch on the appliance.
2. Unplug the mains plug from the power source.
ð This disconnects the appliance from the power supply at all poles.
To Next Page
Loading...
