Memmert UNplus - Manual Mode

Operation and Control
30 D53182 02/2024
The example on the right shows the appliance in manual mode, as indicated by the
coloured hand symbol.
When the appliance is in timer mode, Timer active is displayed.
When the appliance is in remote control mode, the symbol appears in the temperature
display.
See also
2 Manual Mode [}30]
2 Digital Backwards Counter [}31]
2 Programme Mode [}32]
2 Remote Control [}47]
6.5.1 Manual Mode
In this operating mode, the appliance runs continuously with the values set on the
ControlCOCKPIT.
As described in chapter }6.4.2Basic Operation, you can set the following parameters after
pressing the corresponding activation key (in any sequence):
Temperature
Heating operation is indicated by the symbol.
You can display the temperature in °C or °F.
The setting range depends on the appliance (see }3.6Nameplate and
}3.7Technical Data).
Air flap position
Setting range: 0% (closed, recirculating operation) up to 100% (fully open, fresh air
operation) in 10% increments.
Fan speed
(only for appliances with interior fan)
Adjustment options: 0 to 100% in 10% increments