91
12. By selecting the Q monitor set the operator can then select a Source or sum multiple sources,
those will be monitored exclusively on this Cue (Q) Monitor set.
Cues are recommended when needing to monitor a different selection of sources for a
designated Monitor set (e.g. If you want headphones to monitor something different than the
Speaker set, use a Cue). Cues can also be used when recording to produce a low-latency Cue mix
for the performer foldback.
Note: To configure the Built-in Talkback for the performer's headphones, refer to the Talkback use
case.
You are ready to start recording with Anubis and have a Musician using an Ultra-Low Latency
Cue (Q) Monitor set.
To Next Page
Loading...
