90
7. How to create a Cue Monitor. First enter the Settings>Monitor page and create a new Monitor
Set. Tap this new entry to enter the monitor setting.
Note: Users can edit existing Monitor sets and change their mode to Cue.
8. Under Monitor Mode, select Cue
9. Assign this Cue to the button of your choice. Here we will assign the Cue to the VirtualKey 1.
10. Make sure that the cue is properly patched in the lower Channel section of the Monitor set.
Here we are patching the Cue to the Headphones 1 (left and Right Channels)
Warning: Patching already patched channels will be disconnect if those are used within another
Monitor set, as a designated output can only be Patched once within all Monitor Sets. This rule does
not apply to Sources and Inputs.
11. Return to the Source Page where you will now find a Q1 (Cue) Monitor available on the
VirtualKey 1.
To Next Page
Loading...
