Metor 6M - Remote Control Unit Communication Setup

PAGE 26 Metor 6M
Installation and Operating Manual
7. SWITCHING ON 92102916 REV 5
Keypad
All functions of the WTMD are controlled
with the display unit.
This button is used to accept the
functions selected and the changes made
to settings, as well as to navigate the
menus.
The arrow keys are
used for navigation of menus and to
change the settings.
This button is used to return to a
higher menu level or to cancel the current
function without changing the settings.
This button can also operate as a standby
switch. During standby mode metal
detection is disabled, traffic lights, display
and possible power indications are turned
off. As a default standby mode is OFF but it
can be enabled/disabled from user
interface. See chapter 13. When enabled
pressing for 2 seconds in normal
operation will turn Metor 6M into standby
mode.
This button is used to set the volume
(no access code required).
This button can be pressed to receive
instructions.
This button is used to access the
unit’s settings for editing or to directly enter
numeric values. You can enter a value by
pressing the corresponding number key(s).
3
2
5
?
C
7
12
3
9
8
1
OK
4
0
6
F1
OK
OK
0
1 2 3
C
C
4
5
?
7
12
3