PAGE 6 Metor 6M
Installation and Operating Manual
2. IMPORTANT INSTRUCTIONS 92102916 REV 5
2. IMPORTANT INSTRUCTIONS
• The instructions in this manual shall be followed in all situations, when
installing, using, or servicing the equipment.
• Rapiscan Systems cannot be held responsible for any material or personal
damage caused by use contradicting the instructions given in this manual.
DANGER
Read through this chapter carefully before operating the equipment.
Keep this manual so that it is always readily available to the user.
All safety regulations must be observed. A dangerous or unsafe manner of
operation may be a health risk.
Installation may only be carried out by a qualified person.
Before installing, operating or servicing the equipment, make sure that it
poses no risk of personal or material damage.
Be aware that although the walk through metal detector unit is heavy it may
fall down if a heavy force collides with it. To eliminate the risk of
overbalancing the WTMD must be attached (anchored) on the floor.
Do not operate the unit unless you are fully trained to do so. The operator
must know the use, service, and safety instructions of the unit, and local
safety regulations.
Only authorized service personnel are allowed to do maintenance work.
Make sure that there are no unauthorized persons in the working area when
servicing and repairing the equipment.
It is forbidden to operate the equipment when ill, or under the influence of
alcohol or drugs.
The equipment may not be connected to mains supply until all other
connections necessary for the installation are completed.
The equipment shall always be connected to an earthed socket outlet.
The equipment shall be disconnected from mains supply before servicing,
cleaning, or moving it.
Original Metor spare parts shall be exclusively used.
To Next Page
Loading...