PAGE 52 Metor 6M
Installation and Operating Manual
11. ACCESSIBILITY PARAMETERS 92102916 REV 5
Access codes
The equipment has two factory-set user IDs. They are IDs 0 and 1.
User 0 belongs to the user group "SUPERUSER" and has access to all menus. The
factory setting for the access code is "1, 2, 3". User 0 can not be deleted, and
"SUPERUSER" user group can not be modified.
User 1 belongs to the user group "USER". It has limited access to the menus. The
factory setting for the access code is "7, 8, 9". User 1 can be deleted, and user
group "USER" can be modified.
COPY FROM
METOR =>
REMOTE
Copies the current user IDs and group definitions into
the remote control unit. The settings copied into the
remote control unit will remain there until new settings
are copied in their place. Aim the remote control unit at
the display unit until the WTMD indicates that copying
has been completed successfully (completed OK). The
copying will take a few seconds.
COPY FROM
REMOTE =>
METOR
Copies the user IDs and group definitions from the
remote control unit to the WTMD. The current user IDs
and group definitions in the WTMD will be overwritten
and the new definitions are applied immediately. Aim the
remote control unit at the display unit until the WTMD
indicates that copying has been completed successfully
(completed OK). The copying will take a few seconds.
REMOVE ALL
VALID
REMOTES
All remote control units can be removed from the unit’s
memory.
LOGIN TYPE Numeric /
Alphanumeric
Numeric The operator can choose between alphanumeric and
numeric type of access code.
KEYPAD
DISABLE
On/Off Off Can be turned On only with a remote control. When
turned On keypad is not functioning, but remote control
is. If remote controls are removed function must be
turned Off.
To Next Page
Loading...