Metor 6M - Creating New User IDs

Metor 6M PAGE 53
Installation and Operating Manual
92102916 REV 5 11. ACCESSIBILITY PARAMETERS
Changing the access code of User 0
1. Press . When the program requests “ENTER USER ID:”, enter “0”. 
Press .
2. Enter the User 0 access code, and press .
3. Press , twice to display “Accessibility parameters”.
4. Press , three times to display “Change own access code”, then press .
5. The program requests: CONFIRM OPERATION “OK“=YES “C“=CANCEL.
Press OK.
6. Enter the new code, then press
.
7. Re-enter the new code, and press . The text “Operation completed OK”
will be displayed.
8. Hold down for a moment to return to normal mode.
Changing the access code of another user
Follow the procedure above, but use menu item "Change User N Access Code"
instead.
Note that you must login as a user that belongs to a user group that has access to
the menu item mentioned above.
Using alphanumeric access code (Login type)
Select the alphanumeric entering of the access code from the menu 
(Accessibility parameters -> Login parameters -> Login type). 
After that the access code can be changed normally according to the following
instructions:
1. When entering access code, select the first character by scrolling down or
up the list of characters.
2. When the right character is selected, accept it with
.
3. Choose the next character and accept it. If you chose the wrong character, you
can delete it with
.
4. When the access code is entered, press .
OK
OK
OK
OK
OK
OK
2
3
OK
OK
OK
OK
OK
OK
C
2
0
3
C
OK
OK