Metrohm Titrando User Manual

1.4 Safety notes
8 Titrando Installation Instructions
1.4 Safety notes
Warning!
This instrument should only be used in accordance with the informa-
tion given in these installation instructions.
1.4.1 Electrical safety
Please observe the following guidelines:
• Only qualified Metrohm technicians should carry out service work
on electronic components.
• Do not open the Titrando housing. This could destroy the Titrando.
Inside the housing there are no components that the user can ser-
vice or exchange.
Electrical safety when handling the Titrando is guaranteed within the
framework of the IEC 61010 Standard. The following point must be ob-
served:
Protection against electrostatic charges
Warning!
Electronic components are sensitive to electrostatic charges and can
be destroyed by a discharge. Always remove the mains cable from
the power supply socket before setting up or breaking electrical con-
nections on the rear panel of the instrument.

Metrohm Titrando Specifications

General

mV Resolution	0.1 mV
Temperature Resolution	0.1 °C
Applications	Acid-base, redox, complexometric, precipitation, Karl Fischer titration
Measuring inputs	pH, mV, temperature
Stirrer control	Integrated stirrer control
Software	tiamo
Titration Methods	MET (Monotonic Equivalence Titration), SET (Fixed Equivalence Titration)
Dosing Resolution	Varies depending on the Dosing device used
Minimum Dosing Volume	Varies depending on the Dosing device used
pH Resolution	0.001
Interface	USB
Power Supply	100 – 240 V AC (depending on the model)
Dimensions	Varies depending on the model
Weight	Varies depending on the model