102
BATTERY
Without maintenance
Tension : 12 Volts
in a normal use, there is no level
control to do.
REMOVAL
Unplug the battery using the red speed (+) disconnecting
cable terminal
Untighten the holding angle bracket to take out the
battery from its support.
Before any intervention on the electric circuits
unplug the battery.
Be carefull not to short circuit the terminal with a tool
or any metal piece, this could damage the battery
The battery contain some acid which is a toxic and
corosive product. Wear some security glasses
when you manipulate the battery and be carefull
not dropping the electrolyte on you,
your clothes or the car.
your clothes or the car
In case of contact with the electrolyte, wash the
damaged clothes and wash yourself abundantly.
ELECTRIC EQUIPMENT
Fitting back
Check the good direction of the terminals.
Battery loading
Before loading , you must unplug the battery.
Plug cerrectly the loader (check the using form
of the loader.
Plug back your cables starting by the + and
finishing by the -.
Wintering
Dismantle your battery in case of long stop of your car
when it is very cold.
Load it if need be when you start it.
Lights board
FRONT
Light 60/55WH7
Code 60/55W H7
Side lights 5 WW5W
Indicator 21WP21.W
BACK
Stop 21 W P21.W
Indicat 21WP21.W
Reverser 21WP21.W
Rear light fog 21WP21.W
3rd stop light , 5WW5W
INTERIOR
Interio light 5WW5W
Lantern 5WR5.W
To Next Page
Loading...
Need help?
General
