99
Fill in the tank with braking liquid
Nota : make the bleeding after : every repairing
during which one the braking circuit has been
opened, and when it is necessary to push several
times on the pedal to obtain the braking or if
you feel an elasticity in the pedal.
BRAKING WITH A SPECIAL
MACHINE
• Follow the form of the constructor of the
used machine
• Start the bleeding by the wheel the faster of
the master cylinder and do as follow : back
right wheel, back left wheel, front right wheel
front left wheel
•Do not use again the drained brake liquid.
• Seal the air braking screws with the dust
covers after having made the braking.
• Press several times on the braking pedal
• Fill the liquid in the tank, at the end of the
circuit bleeding
• Make a try.
BRAKING HYDRAULIC CIRCUIT BLEEDING
BLEEDING WITHOUT SPECIAL MACHINE
Nota - During the bleeding operations, check if the level of the
liquid in the tank stays at the minimum.
•Control and if need be complete the level of the liquid
in the compensation tank. The bleeding must be made as
follow : back right wheel, back left wheel, front right wheel
front left wheel
• Take off the dust cover of the bleeding screw, connect the
tuyau de purge en laissant plbleeding tube letting plunge
the other end in a transparent container.
• With a apropriated key, open the bleeding screw with a half turn
and press on the brake pedal several times and in its total run
till the liquid which goes out don't have any air bubble
anymore
• Close the bleeding screw when the brake pedal is pressed
2 persons are necessary to make the bleeding in these
conditions. It is also necessary to always complete the level
of brake liquid which has gone out.
• Do the same on the other wheels in the indicated way
• Put back all the caps on every bleeding screw.
• Control the new level of the brake liquid in the tank and fill in
if need be.
• Press several times on the brake pedal.
To Next Page
Loading...
Need help?
General
