52
ABS REPAIRING
When the ABS is broken or deeply scratched, with a drilling
machine, make a hole at the 2 ends to stop the break.
Do a milling on a deep scratch
(see drawing)
Make a milling on the both sides on a break
(see drawing)
Always use an appropriate cut speed
to avoid making the ABS melted down.
faire fondre l’ABS.
Use the following products to repair the ABS
A - ABS degreasing (réf. 1 003 036)
B - Kalico fiber (réf. 1 003 037)
C - Waterproof sticky strip (réf. 1 003 038)
D - ABS repairing kit + 2 mixers (réf. 1 002 656)
E - Mixers 50 cc (réf. 0 700 249)
In case of scratch :
• Wet lightly a rag with the degreasing (A) and degrease the
surface which is to glue.
In case of break :
• Wet lightly a rag with the degreasing (A) and degrease the
surface which is to glue.
Break
Scratch
A
C
D
B
E
• Fill in again the break using te reparing ABS kit (D).
Drying time : 3 hours
Do not make the degreasing poured too much
on the ABS
Do not make the degreasing poured too much
on the ABS
• Apply a sticky strip (C)on the break, outside to avoid
excess glue.
To Next Page
Loading...
