37
BACK WHEEL TRIM REMOVAL
With damaged wood scissors and a thermal scrapper
unglue the wheel trim rear quarte panel from the back wing.
Unglue the wheel trim from the pillaracting from low to high.
With a Stanley knife, cut the upper joint next to the ABS of the wheel
trim.
Heat and unglue the covering of the roof.
BACK WING REMOVAL
Remove the hatchback (see page 14)
Remove the back bumpers (see page 23)
Remove the inside trim (see page 25)
Remove the back lights.
Remove the quarter light (see page 36)
Unglue and take off the rear side panel groove.
Do not warm up the ABS more than 60°
It is better to use an adjustable thermal scrapper.
Do not warm up the ABS of the roof more than 60°
To Next Page
Loading...