Microcar MC1 User Manual

38
Take out the striker plate.
With a screwdriver, take out the filler neck.
Disconnect the chute of the body.
With wood scissors and thermal scrapper, unglue the upper part
of the back wing.
Warm up the last points where the glue catches respecting the
maximum temperature not to damage the other ABS pieces
and take out the back wheel trim.
NOTA : When reassembly, the wheel trim must imperatively be
replaced by a new piece.
Do not warm up the ABS more than 60°

Microcar MC1 Specifications

General

Brand	Microcar
Model	MC1
Category	Automobile
Language	English