REAR QUARTER PANELWINDOW REMOVAL
Insert a piano rope between the door pillar and the rear quarter panel.
The piano rope is inside the window glue kit ref 0700200
Cut the glue joint on the side of the window and take it out.
Take care not to cut the inside trim.
For the assembly of the rear quarter panel window, clean all the
residues of the glue which stay on the body.
To glue the rear quarter panel window, use the kit glue (ref 0700200)
and the primary ABS (ref 1002818).
• Degrease (Adhekit ref. 1002659) or alcool.
• Apply the primary of the glue kit (ref 0700200) on the alu surfaces
(1) and on the side of the quarter light gluing surface.
• Apply the primary (réf. 1 002 818) on the ABS (2).
Apply a line of the glue which is in the kit on the primary and
lift up the window, check its well centring on the body and hold
it in position with strips.
Stop the car during the 6 following hours.
To have a perfect window, you must primarise
the 2 parts to glue.
The primaries must be applied at least 5 minutes
before the gluing of the windows.
The primaries keep their efficiency during 72
hours.
To Next Page
Loading...
