18
Loosen the 2 compass ball joints.
(Set screw when fitting again 4,2 N/m).
Take out the 2 ball joints with nuts and washers.
Unglue the window from the hatchback.
Use the piano rope given in the gluing window kit
(réf. 0 700 200).
Make the cable slided between the window and the hatchback
on all length.
Use the gluing kit (ref 0700200) taking care of cleaning the
surfaces which must be glued.
Apply the primary of the kit on all the length of the window
Apply the primary (réf. 1 002 818) on the ABS of the hatchback.
Take out all the wastes of the
previous gluing.
Be carefull not to damage the ABS of the hatchback.
The reassembly of the rear door is made at the reverse
from the removal operations.
It is necessary to put the primary on all the parts
which must be glued (windows and body).
Put a line of glue on the primary.
Fit again the window on the hatchback and fix it with
2 ball joints + washers + nuts (set screw 4,2 N/m)
Let dry during 6 hours before doing new manipulations
Some primaries can damage the ABS.
It is necessary to apply the primary 5 minutes
before gluing. This one keeps its efficiency during
72 hours at the maximum.
To Next Page
Loading...
Need help?
General
