40
Remove the piece from the back carcase pillar.
Remove the low part on the back cross beam.
Take out the back waterproof pieces.
Use the glue kit TWINTEX -ABS-ALU ref 1002657
The fitting is done at the reverse from the removal operations.
With wood scissors, remove the back waterproof pieces.
NOTA: Those operations do not necessarily require
the use of a thermal scrapper.
BACK WATERPROOF PIECE REMOVAL
Degrease the parts which must be glued with the
product in the kit (ref 1002659)
Clean all pieces which must be fitted again.
Clean all the glue residues which stay on the pieces which must be
assembled.
To Next Page
Loading...
Need help?
General
