69
Before untightening all the fixing of the changer bridge
wedge the underneath of the engine sump to prevent
it from tipping.
Take out the 2 fixing bolts of the changer bridge on the back rubber
mounting.
(set screw when fitting back 12N/m)
• Untighten the 2 fixing screws of the changer bridge support
(set screw when fitting back 30N/m).
•Hold the changer bridge and take out the 2 fixing screws (A)
(see drawing)
• Take out the changer bridge from below the car.
• Make the fitting at the reverse from the removal operations.
Take out the receiver pulley of the variator (see page 66).
Uncouple the changer bridge switch command
Unplug the speed sensor.
A
To Next Page
Loading...
