Appendix E AccuPyc II 1340
E-4 Dec 2011
6. Attach the hardwired power adapter cable to the lower connector labeled Module
Connection on the rear panel of the analysis module. Be sure to use the lower connector
on the analysis module; the upper connector is for attaching another analysis module.
7. Plug the external power supply cables into electrical wall outlets.
8. Place the On/Off switch on the rear panel of the analyzer in the On ( | ) position.
9. Calibrate the Analysis module using the Calibration Kit shipped with your system. Refer
to Calibrating the Pycnometer in Chapter 2 for step-by-step instructions.
To Next Page
Loading...
