AccuPyc II 1340 Appendix J
June 2013 J-3
10-, 3.5-, and 35-cm
3
Inserts
Simply remove the chamber cap and place the insert into the sample chamber. The insert
should fit snugly in the chamber. Place the appropriate sample cup into the well of the insert.
Be sure to install the fritted filter cap (if used) before closing the sample chamber. A fritted fil-
ter cap is used to constrict gas flow, and is included with some inserts. The fritted filter cap for
the 10-cm
3
insert fits on the top of the sample cup. The fritted filter caps for the 1- and 3.5-cm
3
inserts fit on the top of the insert. Fritted filter caps are not available for the 0.1- and 35-cm
3
inserts.
Do not force the insert or cup into the openings; the instrument, insert, or cup may be
damaged.
To Next Page
Loading...
