AccuPyc II 1340 Starting an Analysis
June 2013 4-5
Canceling an Analysis
You may cancel an analysis that is in progress by pressing Alt + CLEAR. The following mes-
sage is displayed:
Press
ENTER within five seconds to cancel the operation; notification that the automatic oper-
ation has been cancelled will be displayed.
When you cancel an operation, messages are displayed indicating that termination is in prog-
ress. The termination process, which vents the system, takes about 30 seconds and returns to
the Reload prompt.
If you wish to view the data that have been collected, press
CHOICE; the following prompt is
displayed if no cycles have been completed.
Unit[n] SN1234 10 cm3
Analyze
[Enter] to cancel
automatic operation.
Unit[n] SN1234 10 cm3
X - X - X
DTA_ERR:
No data to compute
To Next Page
Loading...
