Reviewing Data AccuPyc II 1340
4-8 June 2013
Calibration Data
The prompts that display during a review of calibration data depend on the options you specify
in Set Up > Analysis Parameters and Report Options.
You may edit the information in the prompts if desired.
1. Press
Alt + 5; the Chamber Insert prompt showing the insert (if used) is displayed.
2. Press
ENTER; the volume of the calibration standard is displayed.
3. Press
ENTER; the Which Chamber prompt is displayed.
4. Press
CHOICE to select the chamber for which you wish to view volume results.
5. Press
ENTER; a prompt displaying the starting time and date is displayed.
6. Press
ENTER; a prompt displaying the ending time and date is displayed.
7. Press
ENTER; the first of the prompts containing data is displayed.
or
The [n] displayed in the example prompts represent the cycle number.
8. Continuing pressing
ENTER to view all of the data.
Press
CHOICE to exclude data from report calculations; an asterisk will display
indicating that it will be excluded.
9. Press
SAVE to return to the Reload prompt
10. For a record of calibration data, press
Alt + 6 to print to an attached printer.
Unit[n] SN1234 10 cm3
X - X - X
Cell [n] = (volume)
Dev [n] = (deviation)
Unit[n] SN1234 10 cm3
X - X - X
Exp [n] = (volume)
Dev [n] = (deviation)
To Next Page
Loading...
