Controls, Indicators, and Connectors AccuPyc II 1340
3-2 Aug 2013
Rear Panel
Keypad Enables you to enter commands for the analyzer. Refer to
Pycnometer Keypad, page 3-4 for a description of the
keypad.
Brightness control Enables you to adjust the brightness of the display.
Insert a small-blade screwdriver into the opening. Rotate the
screwdriver until you feel it engage in the slot, then turn
clockwise to darken and counterclockwise to lighten.
Ethernet port This port can be used to connect to a network enabling you to
be notified via e-mail of analysis completion, and to monitor
analysis results using a web browser. A straight-through or
cross-over ethernet cable can be used since the analyzer will
adapt to either type.
USB connectors For attaching external devices, such as a printer, bar code
reader, or keyboard. This connector is also used to install
software upgrades.
On/Off switch For turning the analyzer on and off
Ethernet port
USB connectors
RS232 port
On/Off switch
Power connector
Gas inlet port
Analy-
sis
mod-
Bright
ness
To Next Page
Loading...
