Installing the Analyzer AccuPyc II 1340
2-10 June 2013
4. Run your index finger around the O-ring groove.
5. Replace the chamber cap; turn the cap clockwise to close it.
Specifying System Options
The pycnometer is shipped with system defaults as follows:
If you wish to accept these defaults, proceed to Calibrating the Pycnometer on the next page.
If you wish to change the defaults:
1. Press
ALT + 2 to access the Set-up type prompt.
2. Refer to Unit Types, page 3-22 for details on changing these options.
3. Edit the desired options, then press
SAVE to save all changes and return to the Reload
prompt.
Option Choices Default
Pressure units kPag, psig psig
Language English, French, German, Italian, Spanish English
Date/Time Set for Eastern Standard Time (EST), USA at time of shipment
Unit[n] SN1234 10 cm3
X - O - X
Set-up type?
Analysis parameters
To Next Page
Loading...
