System Commands AccuPyc II 1340
3-22 Aug 2013
Unit Types
These prompts enable you to specify the:
• units of measurement
• operating language
• current date and time
Press
CHOICE until Unit Types is displayed, then press
ENTER.
This prompt enables you to choose the units you wish to
display for reports.
Choices: psig (pounds per square inch gauge)
kPag (kilopascal gauge)
Press
CHOICE to select the desired unit, then press ENTER.
This prompt enables you to choose the operating language.
Choices: English, Deutsch, Español, Francais, Italiano
Once you select a language, the change is effective
immediately; you do not have to press
SAVE. For example;
if you choose Italiano, the next prompt will display in
Italian.
However, any error messages that may be in the message
queue will remain in English (or the current selected
language); they will not be translated. Error messages that
occur after you select the language will display in that
language.
Keypad overlays containing translations for the alternate
functions printed above the keys are available for each
language (refer to ORDERING INFORMATION, page 6-
1).
Choose the desired language, then press
ENTER.
Unit[n] SN1234 10 cm3
Set-up Type?
Unit Types
Unit[n] SN1234 10 cm3
Unit Types
Pressure units?
psig
Unit[n] SN1234 10 cm3
Unit Types
Language?
English
To Next Page
Loading...
