Micromeritics AccuPyc II 1340 - Review

System Commands AccuPyc II 1340
3-30 Aug 2013
Review
The Review function enables you to review results of the last operation (analysis or calibration).
Analysis
Press Alt + 5 to review or edit analysis results; the following prompts display if requested. You may
edit the information in the prompts if desired; for example, you may wish to edit the sample mass
when density determinations are requested.
Displays the identification entered for the analysis.
Press
ENTER.
Displays the sample mass you entered for the analysis (if
Density was chosen as Analysis display mode).
Press
ENTER.
Displays the sample chamber temperature.
Press
ENTER.
Displays the time and date the analysis began.
Press
ENTER.
Displays the time and date the analysis completed.
Press
ENTER.
Unit[n] SN1234 10 cm3
X - X - X
Sample ID:
(sample identification)
Unit[n] SN1234 10 cm3
X - X - X
Sample Mass:
(mass)
Unit[n] SN1234 10 cm3
X - X - X
Temperature:
(sample chamber temperature)
Unit[n] SN1234 10 cm3
X - X - X
Start:
(HH:MM:SS) (DD/MM/YY)
Unit[n] SN1234 10 cm3
X - X - X
End:
(HH:MM:SS) (DD/MM/YY)