AccuPyc II 1340 Appendix K
Apr 07 K-3
Connecting the Gas Supply
Four pieces of gas supply tubing are supplied, allowing you to connect up to four gases to the
assembly.
1. Connect one end of the gas supply tubing to the gas supply (refer to Rear Panel
Connections if you need assistance).
2. Insert the other end of the tubing into one of the valve inlets on the Multigas assembly.
3. The faceplate of the valve assembly contains four sections; one for each gas inlet on the
assembly. Write the name of the gas in the applicable section. For example, label the inlet
He for helium.
Selecting Gases
After you have the gases installed, use the knob to select the desired gas. Be sure to purge the
gas lines when you change gases.
Write the name of the gas
attached to the inlet.
Turn the knob to the desired gas.
To Next Page
Loading...
