AccuPyc II 1340 Appendix I
Nov 06 I-1
I. KEYBOARD INTERFACE
A computer keyboard attached to the USB port enables you to enter alphanumeric characters
at certain prompts; for example, the Sample ID and Description prompts. So that you do not
have to switch back and forth between the computer keyboard and the analyzer keypad, all
system commands are available through the keyboard. Tables I-1 and I-2 provide computer
keyboard equivalents for the functions on the analyzer keypad.
Table I-1. Alternate Functions
Function Key Sequence Used To
Keypad Keyboard
Analyze
Alt + 4Ctrl + A
Perform an analysis.
Calibrate
Alt + .
(decimal)
Ctrl + O
Calibrate the pycnometer.
Escape
Alt + CLEAR Esc
Discard all data entered in the current mode
and return to display mode.
Cancel an automatic operation in progress.
Exit manual mode.
Manual
Alt + 1Ctrl + Y
Enables manual mode, allowing you to open
and close the Fill (Key 7), Expand (Key 8),
and Vent (Key 9) valves.
The state of the valve is shown on the second
line of the display, where X = closed and O =
open.
Press
Alt + CLEAR to exit manual mode and
return to the Reload prompt.
Print
Alt + 6Ctrl + P
Print an analysis or calibration report. If an
automatic operation is in progress, print a
partial report.
Review
Alt + 5Ctrl + R
Review completed analysis or calibration
data.
Set Up
Alt + 2Ctrl + U
Display or edit analysis parameters, report
options, calibration data, data transmission
parameters, unit types, operating language,
and date and time.
To Next Page
Loading...
