Installing Software Upgrades AccuPyc II 1340
2-16 June 2013
Installing Software Upgrades
1. Place the On/Off switch on the rear panel in the Off ( O ) position.
2. Insert the USB media containing the software update into one of the USB connectors on
the rear panel.
3. Place the On/Off switch in the On ( | ) position.
4. The software starts to load after initialization (approximately 1-2 minutes); the following
prompt is displayed:
5. The following prompt displays after the software update is loaded:
6. Remove the USB media and store in a secure location.
USB connectors
On/Off switch
Updating Application
from USB Media
Update Successful
Remove USB Media
To Next Page
Loading...
