AccuPyc II 1340 System Commands
Aug 2013 3-33
Print
Press Alt + 6 to print a report of the last operation; analysis or calibration. If you press Alt + 6 during
an automatic operation, a partial report is printed.
Reports are generated after analysis and calibration, and remain available for viewing or printing until
another automatic operation (other than zero pressure) is performed. When you perform an automatic
operation, reports from the previous operation are deleted.
Data for up to five analyses, however, are stored in the control module for each analysis module
attached. These data can be viewed using a web browser when connected to a network via an ethernet
connection. Refer to Communications, page 3-18 for additional information on this feature.
A printed report contains more information than the report generated to the display, and is easier to
read. It also provides a hard copy of data results. An asterisk next to a cycle number indicates that it
has not been included in calculations.
The following examples show reports for a calibration on a standard and an analysis performed on the
same standard
.
To Next Page
Loading...
