Appendix J AccuPyc II 1340
J-4 June 2013
1- and 0.1-cm
3
Inserts
Special tools are required for installing the 1- and 0.1-cm
3
inserts; these tools are included in
the appropriate MultiVolume kits.
1-cm
3
Insert and Sample Cup
Perform the following steps to install the 1-cm
3
insert and sample cup:
1. Remove the sample chamber cap and place on a clean work surface with the greased side
facing upward. The cell chamber cap should be left off the sample chamber a minimal
amount of time to prevent contamination from airborne particles.
2. Place the insert into the sample chamber.
3. Use the handling tool to grasp the cup for placement in the insert. After placing the sample
into the sample cup, insert the tip of the tool into the cup and press down firmly. The
handling tool features an O-ring to grip the inside surface of the sample cup.
To Next Page
Loading...
