Micromeritics AccuPyc II 1340 - Page 30

Installing the Analyzer AccuPyc II 1340
2-12 June 2013
4. Press ENTER; accept the default of 10 for the number of cycles.
5. Press
ENTER; accept the default cycle fill pressure of 19.500 psig.
6. Press
ENTER; accept the default of Equilibrate.
7. Press
ENTER; accept the default value of 0.005 psig/min.
8. Press
ENTER; accept the default.
9. Press
SAVE to save the values and return to the Reload prompt.
Unit[n] SN1234 10 cm3
Analysis Parameters
Number of Cycles:
10
Unit[n] SN1234 10 cm3
Analysis Parameters
Cycle Fill Pressure:
19.500 psig
Unit[n] SN1234 10 cm3
Analysis Parameters
P1, P2 end by?
Equilibrate
Unit[n] SN1234 10 cm3
Analysis Parameters
Equilibration Rate:
0.005 psig/min
Unit[n] SN1234 10 cm3
Analysis Parameters
Use Run Precision?
No