AccuPyc II 1340 Pycnometer Keypad
Aug 2013 3-7
Set Up
Alt + 2
Display or edit analysis parameters, report
options, calibration data, data transmission
parameters, unit types, operating language,
and date and time.
Transmit
Alt + 3
Transmit analysis or calibration data over
the serial line. Transmit a partial report if an
automatic operation is in progress.
Escape
Alt + CLEAR
Discard all data entered in the current mode
and return to the Reload prompt.
Cancel an automatic operation if in
progress.
Exit manual mode.
Analyze
Alt + 4
Perform an analysis.
Review
Alt + 5
Review completed analysis or calibration
data.
Print
Alt + 6
Print an analysis or calibration report. If an
automatic operation is in progress, print a
partial report.
Unit
Alt + CHOICE + [unit
number]
Select the unit you plan to use for the
current operation.
This command is used when multiple
analysis units are attached. For example; if
you have five units attached and you plan to
use unit three for the next analysis, press
Alt
+ CHOICE + 3
; any command you use will
apply to unit three.
You can also use the Unit command to view
the progress of an analysis when multiple
units are attached. For example; if you have
analyses in progress on units one, two, and
three; press
Alt + CHOICE + 2 to view the
status of the analysis on unit two.
Function Key(s) Use To (continued)
To Next Page
Loading...
