196 Chapter 21: Scope (Automation)
PRO1 Live Audio System
Operator Manual
>> To select a single parameter section
1 Click SINGLE.
2 Click the desired parameter section (shown right).
In some cases more than one parameter section may be selected. This
may occur if:
• The parameter section belongs to a channel that is stereo linked. The
equivalent parameter section of the other paired channel will also be
selected.
• Other channels are patched to the same source as the channel in which
you are making your selection. This only applies to the All and Mic
Amp parameter sections.
>> To select a parameter section in all channels of a single type
1 Click BY CHANNEL TYPE.
2 Click the desired parameter
section in any channel of the
desired type. For example, click
the routing parameter section in
any of the input channels. The
routing parameter section on all
input channels will be selected (as
shown right).
>> To select all of the parameters of a single channel
1 Click INDV. CHANNEL.
2 Click any parameter section in the desired channel. For example,
click the All parameter of input channel 5; all the parameter
sections in channel 5 are selected (as shown right).
If the channel is stereo linked, all of the parameter sections in its paired
channel will also be selected.
To Next Page
Loading...
Need help?
General
