198 Chapter 21: Scope (Automation)
PRO1 Live Audio System
Operator Manual
Selecting bus parameters
As a channel’s bus parameter section represents all of its available buses collectively,
you can only select either all or none of its buses using the scope function buttons.
However, by clicking the bus parameter section you can open its ‘bus select’ window,
which lets you select any buses you want out of scene. In this window each aux/matrix
bus is represented by an single icon, and only available buses are shown.
Typical ‘bus select’ window
The background colour of the bus parameter for each channel shows the selection
status of its respective buses. There are three states, as shown in the following table.
>> To select/deselect buses
In the ‘bus select’ window, do one of the following:
• To select/deselect a single bus, click on its icon.
• To select/deselect all buses, click All.
Bus selection status Symbol
None of the buses are selected
One or more, but not all, of the buses
are selected
All of the buses are selected
Type and number of
currently selected bus
All available buses
Currently selected bus
(green background)
Unselected bus (blue
background)
Click All to select/
deselect all buses
To Next Page
Loading...
Need help?
General
