Miele G 5705 - Function; Brilliantlight (Select Models); Service; Side Panel Removal

Technical Information
33
G 5xxx
2 Function
2.1 BrilliantLight (Select Models)
4 power LEDs are used to illuminate the interior. 2 power LEDs are located at
the top of the door and the other 2 are located in the interior sides of the
cabinet.
When the door is opened more than approximately 12°, the light is switched
on and its brightness increases slowly. If the door is open for longer than 15
minutes or closed less than 12°, the light is dimmed and switched off.
Note: BrilliantLight can be deactivated by the customer.
4 Service
4.1 Side Panel Removal
1. Uninstall the appliance.
2. Disconnect the appliance from the power supply.
3. Open the door.
4. Remove screw caps as necessary.
5. Remove the three T20 screws securing the appropriate side panel (Figure
010-1, Item 1).
6. Use needlenose pliers to squeeze the retainer in the corner (Figure 010-
1, Item 2) and release it from the casing.
7. Remove the side panel from the casing.