Miele G 5705 - Service; Custom Door Panel (GDU) Removal; Door Tension Adjustment; Figure 030-1: Integrated Door Panel Screw Locations

Technical Information
59
G 5xxx
4 Service
4.1 Custom Door Panel (GDU) Removal
1. Remove the screw caps from the sides of the door (2 per side).
2. Support the panel while loosening the 4 screws; see Figure 030-1.
3. Lift/remove the panel from the appliance.
Figure 030-1: Integrated Door Panel Screw Locations
4.2 Door Tension Adjustment
Note:
The front door must be completely assembled before performing the door
adjustment. This includes the installation of the GDU or custom panel.
1. Uninstall the appliance.
2. Disconnect the appliance from the power supply.
3. Remove the toekick.
4. Open the door halfway. See Figure 030-2.
5. Adjust the tension using a T20 screwdriver.
Figure 030-2: Door Tension Adjustment
Important:
1. Loosen the screws only; do
NOT completely remove them.
2. During reassembly, do NOT
over-tighten the screws.
Important:
The door tension should be adjusted
so the door stays in place when
opened. It should neither spring
open nor require a loaded basket to
hold it in place to prevent it from
closin
g
.