Problem solving guide
131
Water inlet and drainage
Problem Possible cause and solution
Check water intake One or more faucets are turned off.
Turn on the faucets.
There was insufficient water in the machine.
Clean the water intake filters.
Turn on the faucets fully.
Water flow pressure is too low. Refer to the technical data.
Contact a qualified plumber.
Noises
Problem Possible cause and solution
Knocking noise in the
wash cabinet.
One or more spray arms are knocking against the wash
load.
Cancel the program. To do this follow the instructions in
“Cancelling a program”.
Arrange the wash load so it cannot obstruct the spray
arms.
Make sure the spray arms can rotate freely.
Re-start the program.
Rattling noise in the wash
cabinet.
Items are insecure in the wash cabinet.
Cancel the program. To do this follow the instructions in
“Cancelling a program”.
Rearrange the load so that items are secure.
Re-start the program.
Knocking noise in the
water pipes.
This may be caused by the on-site installation or the cross-
section of the piping. It has no influence on the function of
the machine.
Contact a suitably qualified plumber.
To Next Page
Loading...
