Program settings
93
Program blocks
The wash block sequence is pre-determined and is the same as the
sequence in the program charts (see “Program charts”).
- Pre-rinse 1 to 3
A pre-rinse removes coarse soiling and foaming agents.
- Main wash 1 and 2
Depending on the load items, cleaning generally takes place at
temperatures between 45°C and 65°C with the addition of
appropriate cleaning agent.
- Interim rinse 1 to 4
In the interim rinse stages, the process chemicals from the
previous wash blocks are rinsed off and neutralized where
necessary by adding appropriate neutralizing agents.
- Final rinse 1 and 2
To avoid deposits and corrosion on the load items, fully
demineralized water should preferably be used if available for the
final rinse.
Thermal disinfection is carried out in accordance with the A
0
concept of ENISO15883 at temperatures between 80 and 95°C
with relevant holding times.
- Drying
Adequate drying reduces the risk of corrosion caused by residual
moisture on the load items.
Program block parameters are accessible only to Miele Service,
with the exception of the dispensing of rinse aid and drying
parameters.
To Next Page
Loading...
