Program settings
95
Altering a program
A program is changed in two steps:
- The program change begins with a list of all wash blocks assigned
to the program. First this list must be confirmed.
- Then individual program parameters can be changed.
Document all changes of factory settings in case of a subsequent
Service call.
Program and dispensing changes must be documented.
...
Program settings
Change program
Change program
Vario TD Dental
Vario TD Intensive
Select the program you want to alter.
For more information see “Allocating wash blocks”.
Allocating wash
blocks
Every program change starts with a list of the wash blocks.
Vario TD Dental
Pre-rinse 1
Accept
All wash blocks, which are assigned to the program, are listed in the
display. The assignment can be adjusted by Miele service if
necessary.
Select the option Accept and confirm with OK.
Further settings follow. You can edit these in any order.
To Next Page
Loading...
