Miele PG 8591 - Program Execution; Selecting and Starting Programs; Delay Start for Programs

Operation
53
Selecting a program
Program selection
buttons
 Select a program using program selection buttons,
or.
Program list
 Press the button,
 use the and arrow buttons to highlight a program, and confirm
your selection with OK.
Vario TD Dental
Temperature
Duration
Min50
55 °C
The LED in the button selected lights up and the relevant program
appears on the display. The LED in the Start/Stop button also starts
to flash.
Another program can be selected at any time before a program has
started. Once it has started, program selection is locked.
The different program and their uses are described in “Program
charts” at the end of these operating instructions.
Always select the program depending on the type of load items and
degree and type of soiling, or on infection prevention issues.
Starting a program
 Close the door.
When the door is closed, the LED in the button will light up.
 Press the Start/Stopbutton.
The LED in the Start/Stopbutton will light up constantly and the
LED in the button will go out.
Starting a
program using
delay start
The start of a program can be delayed; for example, to benefit from
economy rates of electricity at night. Starting from the programmed
time, a delay start time between 1minute and 24hours can be
selected in one minute increments (see “Settings/Time of day”).
Delay start must be switched on (see “Settings/Delay start”).
If soiling is left to dry on the load items for a long time, the
reprocessing result can be adversely affected. There is also a risk
of corrosion for stainless steel load items.